|
|
.
.
.
|
|
Instructions for operation:Download Instruction Manual as a PDF file HERE. |
 |
|
Set Up Connect the Rebel that will be transmitting to a DMX controller by DMX cable, then plug it in and power it up. When the the Rebel and control are connected a transmitting frequency will appear. If there is not a good connection the frequency will not appear or will not stay on a specific channel. Connect the receiving Rebel via DMX cable to the first light in you DMX chain of fixtures (make sure the dip switches are set to your designated value on the fixture). Once the receiving unit is powered up the receiving Rebel will sync up to the transmitting Rebel on the same frequency on it's own. The frequency is shown at the top of the display on the Rebel (T:#.###G). |
 |
Now you must select the ID for the transmitting and receiving Rebels. The rebel has 16 different ID's. This ID tell the transmitter which group of lights to control (located at the bottom right of the display on the Rebel ID:##). Make sure the transmitting and receiving Rebels have the same ID number. Adjust the ID by using the buttons located on the front of the Rebel The Controller should now control your lighting wirelessly. The P:## located on the display is for signal strength. For long distances or through walls you may need more signal strength. Adjust the strength by using the buttons on the front 0-4 and 4 being the strongest. |
 |
 |
 |
 |
