 |
 |
The Lighting you need... at Prices you'll go APE over... |
|
|||||
|
|
|
Instructions for operation:When setting an automatic or sound active option you must press the enter button to lock in your selection. The light will revert back to it's last set function if you do not hit enter.Any time you change something on the digital display, there is a 1 minute delay for your selection to set. |
 |
Stand Alone Mode:On the back digital display press menu until it reads S.H.n.d. Then hit enter, S.H. will start blinking followed by a number from 0-18. Each number is a different set of patterns that the ALOHA will go through to the beat of music. Use the up and down buttons to select your setting. When you find the right setting, make sure to press enter to lock in your selection or the light will revert back to it’s last set function.Master/Slave mode:Set the first fixture to the desired sound active setting. Connect the fixtures by DMX cord. Then, on the second fixtures digital display use menu to find S.L.n.d. and hit enter. Use the up and down buttons to select S.L. 1. Then hit enter again to set it. The light will take a minute to sync up with the master. |
 |
DMX Mode:DMX mode: The ALOHA can be in 2 different DMX modes, 4 channel and 10 channel.4 Channel: On the back display press menu until it reads c.H.n.d. then hit enter. the display will start blinking 4.c.H or 10.c.H. using the up and down buttons select 4.c.H and press enter to lock it in. it will stop blinking. 4 channel mode uses 4 sliders on your DMX controller. Channel #1 Sound active (must be off/down for other features to work) Channel #2 Gobo patterns Channel #3 Strobe Channel #3 Dimmer (must be up for features to work) DMX addressing in 4 channel mode: On the back display press menu until you reach A.D.D.r. Then press enter and set the first fixture to address 1. Set the second fixture to address 5. Go up 4 for each additional fixture. Make sure to press enter after selecting the channel. Any time you change something on the digital display, there is a 1 min delay for your selection to set. |
 |
| 10 Channel On the back display press menu until it reads c.H.n.d. then hit enter. the display will start blinking 4.c.H or 10.c.H. using the up and down buttons select 10.c.H and press enter to lock it in, it will stop blinking. 10 channel mode uses 10 sliders on your DMX controller. Channel #1 Sound active (must be off/down for other features to work) Channel #2 First head pattern Channel #3 Second head pattern Channel #4 Third head pattern Channel #5 Forth head pattern Channel #6 Fifth head pattern Channel #7 Sixth head pattern Channel #8 Seventh head pattern Channel #9 Strobe Channel #10 Dimmer (must be up for features to work) DMX addressing in 10 channel mode: On the back display press menu until you reach A.D.D.r. Then press enter and set the first fixture to address 1. Set the second fixture to address 11. Go up 10 for each additional fixture. Make sure to press enter after selecting the channel. Any time you change something on the digital display, there is a 1 min delay for your selection to set. |
 |
| How to
use this light with the American DJ MyDMX software |
 |
| Includes Black Power Cord. |
 |
Pictures of ALOHA version sold prior to December 2009:  |
 |
| Video of ALOHA version sold prior to 12/09 |
